Easy-Set Logic™ A note about multiple programs Your sprinkler timer provides the flexibility of using 2 independent programs (A, B). The programs are where you store all of your sprinkler settings. Each program consists of a group of stations set to specific start times and run times. Multiple programs allow you to run different valves on different days with different run times. While many applications only require one program (A), using multiple programs (A, B) can be useful for drip areas, newly planted lawn, or rotary sprinkler stations. Using programs to group stations with similar water needs will maximize irrigation efficiency. Primary programming can be accomplished in just a few basic steps. Primary Programming Press the [RESET] to clear any previous factory programming 1. Set Date and Clock • Turn dial to [DATE/CLOCK]. • Press the [+/–] buttons to set the current time of day, then press [ENTER] or [ ]. Tip: To increase or decrease more rapidly, hold down either the [+] or [-] buttons until the display goes into rapid advance mode. • Press the [+/–] buttons to set am/pm, then press [ENTER] or [ ]. • Y/M/D will appear (blinking letter indicates selection). • Press the [+/–] buttons to set the correct year, then press [ENTER] or [ ]. • Press the [+/–] buttons to set the correct month, then press [ENTER] or [ ]. •neodymium n52 Press the [+/–] buttons to set the correct date. • Press [ENTER] or turn dial to accept date. 3. Start time • Turn dial to [START TIME]. • Press the [+/–] buttons to select time you’d like your watering to begin. n52 neodymium magnet(time will adjust in 1 minute increments) The display will show 7 • Press the PROGRAM button to select which program you’d like to set. STATION is the area that will be

Leave a comment

Your email address will not be published. Required fields are marked *